Monday 28 July 2014

More work on Reveller

Starting to put new wood into the boat, the first of the rotten frames that as to be replaced.

A photo of fitting the frame under the bunk front and behind that on to the keel.

A photo of the transom where the bottom is broken away as the stern rubbing skate last screw was screwed to close to the end and spilt the wood.


 A photo of a temporary brace put in place to hold the planking together while the ribs are replaced with new ribs and they are nailed back in place.

A photo of the bottom of the engine room to aft cabin, the area was boxed in with sealed lockers and a hot exhaust running through it, so it became a breeding ground for rot. This time when it is replaced there will be plenty of ventilation.   

A photo of the corner knee getting bolted back in place with stainless bolts.

Friday 25 July 2014

Finally the deck is back on and the trimming up can start the then the varnishing.

Finally the whole deck is in place apart from a small fillet between the two halves of the deck on the top of the transom.

Now it is a matter of waiting for the glue to go off and sand the deck and remove the surplus glue.

Just got to trim up the deck over the transom and fit the centre piece.


 The joint between the side deck and the transom cover pieces.

Tuesday 22 July 2014

Evinrude Outboard repairs

From time to time we get asked to repair older outboard engines mainly Evinrude and Johnson outboards. These are a good engine if looked after, however, in the wrong hands or someone who does not look after them the following problem can and will a raise.

In the case of this 35 HP Evinrude someone in the past as run this engine without water running through the water pump to the extent that the impeller as melted and fused itself to the casing and heated the casing up until the stainless steel casing moved in the plastic housing. 

The following photos show the extent of the damage and the large bill the present owner is going to have to pay for some ones neglect and lack of knowledge when it comes to running their engine out of the water.

The first photo shows the damage to the impeller and the housing.

 The upper housing with the stainless steel housing with melted rubber impeller in the inside of the housing and in the top of the photo the water feed channel blocked by melted plastic and rubber from when the engine was run up with no water going through this housing

This photo is of the melted impeller seized on to the drive shaft due to the great amount of heat produced by the impeller getting hot while running with no water running through the water pump housing.



Tuesday 15 July 2014

Finally got round to finishing off the new deck or at least dry fitting it.

Starting to fit the new side decks to the dinghy after a long break doing other boating projects.
The port side deck when on first.
 

Then the starboard side deck was glued down and then it will be time to trim it up with the trimming router when all the deck is glued down.

Fitting the two parts of the fore deck down the centre line 

Now screw fixing the deck down along the gunwales

Starting to fix the two pieces of deck on top of the transom.




All the deck dry fixed down ready to glue down after the front bulkhead is glassed into position.


Bulkhead all masked up ready to epoxy glass it in place.